Sorption dehumidifier RZ-081
- Stainless steel housing
- SSCR sorption rotor
- Separate control of process and regeneration air
- Electric PTC heater with overheat protection
- With internal heat recovery
Specifications/Instructions:
Download Data sheet_RZ_DE.pdf (429.04 KB)
Download Dimensions_RZ-081R_ICE.pdf (64.83 KB)
| Dehumidification capacity at 20° C and 60% rel. humidity: | 19 kg/h |
| Dehumidification capacity at 30° C and 80% rel. humidity: | 24,3 kg/h |
| Dehumidification capacity at 10° C and 70% rel. humidity: | 13,3 kg/h |
| Dehumidification capacity at 0° C and 90% rel. humidity: | 9,7 kg/h |
| Process airflow, nominal, ext. pressure: |
2.800 m³/h, at 400 Pa ext.
|
| Regeneration air flow, nominal, at ext. pressure: | 1.000 m³/h, at 200 Pa ext. |
| Working temperature: | -20 to +35 °C |
| Working range humidity: | 10 – 100 % rF |
| El. heater, max.: | 24 kW |
| El. motor power, max.: | 3,3 kW |
| El. Total power, max.: | 27,3 kW |
| Supply voltage: | 3x 400V, 50 Hz |
| Fuse: | 50 A |
| Required switch for remote control (e.g., hygrostat or remote ON): | 1 A (control voltage) |
| Hight (total): | 1550 mm |
| Width (total): | 1800 mm |
| Deep (total): | 950 mm |
| Gewicht: | 294 kg |
| Inlet process air: | 400 mm |
| Outlet process air (dry air): | 250 mm |
| Inlet regeneration air: | 200 mm |
| Outlet regeneration air (wet air): | 160 mm |
| Rotor speed: | 46 1/h |
| Filter class: | G3 |
| Applications: | Diverse application areas, to achieve the lowest relative humidity, to dry specific air volumes to specific values, at low temperatures, with wet air extraction to the outside |
| Working principle: | RECUSORB |
| Installation: | Stationary, standing |
| Wet air extraction: | Required |
| Housing: | Steel, galvanized, self-supporting |
| Maintenance Accessibility: | From the front |
| Filter, class: | G3 bag filters for process air and regeneration air, easy and quick access. |
| Fan: | Separate radial fan for process air and reg. air, both direct driven and mounted externally |
| Sorption rotor: | SSCR-U, d 770mm x h 100mm |
| Rotor drive: | Belt driven rotor motor with belt tensioner |
| Regeneration heating: | Electrical PTC heater, thermostatically controlled, seven-stage, total 24 kW |
| Regeneration heating, alternative: | Alternative: steam, gas |
| Thermostat system: | Consisting of safety temperature limiter, control thermostat and wet air temperature limite |
| Electrical equipment: | All components wired to terminal block, main switch, dehumidifier program controller DST C1 with clear display for operating status, operating hours and error messages, control voltage transformer, motor protection groups, fuse automation |
| Control: | (0%, 58%, 100% power), optionally step-by-step or linear heater control via 0-10V control signal |
| Signal: | Remote-ON/OFF, fault message/alarm |
| Supply cable: | No |
| Operating hours counter: | Standard |
| Device connection socket: | No |
| Hygrostat/remote-ON: |
